Despite the continuous improvement and progress of the steel straightening machine to straighten the steel bar cutting more and more relaxed things, but also to involve steel-related construction work more and more efficient, but the operator in the operation of steel straightening Machine, when more or less there will be some due to improper operation or operational errors caused by the problem. Which appears twisted steel bar is more common and more serious problems, that when the operator in the use of straightening machine when the steel bars twist how to do? Today we will provide you with the most scientific solution to the law, together to understand the next bar
    Normally, there are four reasons why the wire is twisted. First, the straightening wheel of the straightening machine does not rotate or the bearing is damaged. For this reason caused by the obstacles, it is recommended that the operator can use the pulley on the straightening wheel maintenance, if it is determined that the bearing is damaged, it is recommended to replace a bearing. Second, the feed wheel selection slot is not appropriate, this situation only need to change the appropriate feeding wheel groove can be resolved. Third, the straight wheel angle is too small, the operator can adjust the steering wheel according to the provisions of the instructions can solve the problem. Fourth, when the straightening wheel is too tight will lead to serious steel wire twist, the general need to adjust the straight turn after the loose no problem.
    If the operator in the use of steel straightening machine when the emergence of a serious steel twist of the situation, the general reason is that the above, we can first find out what causes the problem, and then take the corresponding method to solve Yes.